Service Manual

PAGE 8-A.2
DISASSEMBLY PROCEDURE FOR C0
2
RIFLES -MODELS 160 – 167
Equipped With Trigger Casing Assembly (160-47)
Refer to Drawing Pages 8.7 -8.8
1. Remove Safety Assembly (140 -54) by turning to "SAFE" Position and pulling out of Casing at the same time pushing on other
end of bar.
2. Remove Knurled Nut from bottom of Stock and remove Stock.
3. Remove Casing Screws (140-62 and 160-9A), releasing Trigger Casing Assembly (160 -47) from Tube.
4. Remove 2 Plate Screws (140-37) and Plate (140-40).
Adjust weight Screw (140-39) for the desired trigger pressure. Looking thru the hole in the side of the Trigger Casing, adjust upper
Creep Screw (160-40) for the desired engagement and adjust Lower Creep Screw (160-40) for the desired overtravel. These are set at
the factory at approximately 1/16" engagement and 1/32" overtrave1. This should be done with Casing assembled and on gun.
To reassemble Safety, assemble gun to Stock, depress Safety Rod (140-34) with screwdriver and press Safety Assembly into place.
Safety can be changed for left-handed shooters by removing the Safety Assembly and replacing with the lever on the other side.
Refer to Page 8-A for further disassembly procedure.
NOTE: Old style triggers cannot be replaced with the Trigger Casing Assembly without extensive modification of the Hammer, Tube
and Stock.