Service Manual

PAGE 10.B
MALFUNCTION: CAUSE: CORRECTIVE MEASURE:
111-32 Gasket Leaking Loose Head or Broken Gasket Tighten with Spanner Wrench, replace
gasket.
Filling Head Leaking Foreign particles on seat or
111-41 Check Valve Washer.
Remove Filling Head Ass'y. from Tube,
Remove 111-28 Filling Head Pin, 111-3A
Check Valve Body. Clean or replace 111-41
Check Valve Washer. Clean Seat,
Reassemble.
Filling Head Assembly containing 111-2A, Short Filling Head and 111-3A Check Valve Safety Body.
NOTE: 111-2 Long Filling Head and 111-3 Check Valve Safety Body may be re-used if in good condition. All other parts of assembly
are interchangeable.
SPECIAL TOOLS: SPANNER WRENCH (T-4).
GENERAL INFORMATION ABOUT C02 PISTOL MODELS 111-112-115-116.
COMPRESSION CHAMBER (105-23) and Chamber Locating Pin (105-22) are soldered to Tube.
Breech (111-9) and Front Sight (111-5) are soldered to Tube.
Leaks developed around Chamber Locating Pin (105-22) and between Breech & Tube may be repaired with soft solder.
Valve Nut (110-18) must be tight to prevent leak around Gasket (105-31).
Line up blind hole in Exhaust Valve Body thru bottom of Tube with Locating Pin (T-3) and Hold in place while tightening Valve Nut.
Remove dirt from Chamber and Valve parts before assembling.
NOTE: Exhaust Valve Nut (121-6) must be tight on Stem (105-12).
Examine metal and rubber seats for damage, replace if necessary.