Owner's Manual

Pulse R75
Model SAPR75
6mm BB CO
2
Airsoft BB Repeater
OWNER’S MANUAL
READ ALL INSTRUCTIONS AND WARNINGS IN THIS
MANUAL BEFORE USING THIS AIRSOFT GUN
Crosman Corporation
7629 Routes 5 & 20
East Bloomfield, NY 14443
www.crosman.com
1-800-7AIRGUN
1-800-724-7486 P/N SAPR75-515
Made in China
WARNING:
This is not a toy. Adult supervision is required. Misuse may cause serious in-
jury, especially to the eye. Eye protection designed for airsoft guns must be worn by the user and
any person in range. May be dangerous up to 100 yds . Read the owner’s manual before using.
WARNING:
Do not brandish or display this airsoft gun in public – it may confuse people
and may be a crime. Police and others may think it is a rearm. Do not change the coloration
and markings to make it look more like a rearm. That is dangerous and may be a crime.
NOTE: Charge the battery a MINIMUM of 4 hours and a MAXIMUM of 6 hours prior to initial use. This air-
soft gun will not operate properly without a fully charged battery. DO NOT OVERCHARGE THE BATTERY.
UNPLUG THE BATTERY CHARGER WHEN NOT IN USE.
READ ALL INSTRUCTIONS AND WARNINGS IN THIS MANUAL BEFORE USING THIS AIRSOFT GUN.
BUYER AND USER HAVE THE DUTY TO OBEY ALL LAWS ABOUT THE USE AND OWNERSHIP OF
THIS AIRSOFT GUN.
Recommend 18 years or older to purchase. Intended for use by those 16 or older.
Please read this owner’s manual completely. Remember to treat this airsoft gun with the same respect you
would a firearm. Always carefully follow the safety instructions found in this owner’s manual and keep this
manual in a safe place for future use.
If you have any questions regarding your new airsoft gun, please contact Crosman at 1-800-724-7486,
585-657-6161 or www.crosman.com.
1. Learning the Parts of Your New Airsoft Gun
Learning the names of the parts of your new airsoft gun will help you to understand your owner’s manual.
Use this manual to increase your enjoyment of this airsoft gun.
A. Muzzle
B. Front Sight
C. Hopper
D. Stock
E. Trigger
F. Trigger Guard
G. Battery
H. Butt Release lever
I. Hopper guide rail (see Fig 3A)
J. Safety (see Fig. 2)
2. Operating the Safety
A. To put the airsoft gun “ON SAFE”
• Locate the safety on the right side of the airsoft gun.
• Push the safety forward toward the “S” for “ON SAFE. (Fig 2A). The safety is not “ON SAFE” unless
it is pushed all the way forward toward the “S”.
WARNING:
Keep the airsoft gun in the “ON SAFE” position until you are actually ready to
shoot. Then turn the safety to the “OFF SAFE” position.
Like all mechanical devices, an
airsoft gun safety can fail. Even when
the safety is “ON SAFE”, you should
continue to handle the airsoft gun
safely. NEVER point the Airsoft gun
at any person. NEVER point the
airsoft gun at anything you do not
intend to shoot.
B. To Take the Airsoft Gun
“OFF SAFE”
• Locate the safety on the right side of the airsoft gun.
• Push the safety rearward toward the “F” for fire for “OFF SAFE”. (Fig 2B). The safety is “OFF SAFE”
when it is pushed all the way back toward the “F” positions, and can be fired.
3. Loading and Unloading Plastic BBs
NOTE: For optimum performance Crosman recommends using only
Crosman brand BBs.
A. Installing and Filling the Hopper- Loading Chamber.
• Make sure the airsoft gun is “ON SAFE” (section 2A) and pointed
in a SAFE DIRECTION.
• With the gun held as shown, slide the hopper groove over the
guide rail and push into place. (See Fig. 3A and 3B)
• Slide the hopper door open by pushing it over to the left with your
thumb. (See Fig. 4)
• Fill the hopper with 6mm BBs.
• Close the hopper door. (See Fig. 4)
WARNING:
Use 6 mm plastic BBs only in this airsoft gun. Use of any other ammunition
can cause injury to you or damage to the airsoft gun.
B. Removing Hopper/Unloading Plastic BBs
• Make sure the airsoft gun is “ON SAFE” (section 2A).
• Point the airsoft gun in a SAFE DIRECTION.
• Slide the hopper forward, releasing it from the locked position.
Slide off the gun.
• NOTE: If BBs remain in the hopper, they may fall out when
removing the hopper.
• Point the airsoft gun in a SAFE DIRECTION, take “OFF SAFE” and
fire the gun in a safe direction until no more BBs fire.
• Put the airsoft gun back “ON SAFE”.
WARNING:
Never assume that because the airsoft gun no longer res a BB and/or the
loading chamber is removed, that a BB is not lodged in the barrel. Always treat the airsoft gun as
though it is loaded and with the same respect you would a rearm.
4. Selecting the Firing Mode
NOTE: This airsoft gun fires in semi-auto or full auto mode. Full-auto means
it will continue to fire plastic BBs as long as you hold the trigger. Semi-auto
means that you will have to pull the trigger each time you want to fire a shot.
• Make sure the airsoft gun is “ON SAFE” (section 2A) and pointed in
a SAFE DIRECTION.
• Locate the firing selection dial on the left side of the gun.
• Turn the dial up toward semi for “Semi-auto.” (See Fig. 5)
• Turn the dial down toward full for “Full-auto.”
5. Charging, Loading and Removing the Battery
A. Charging the Battery
NOTE: The battery charging time is a MINIMUM of 4 hours and a
Maximum of 6 hours prior to initial use. Continuous battery consumption
will allow the airsoft gun to shoot for 6-8 minutes. To prolong battery life
and maintain the best shooting performance do not shoot over 5 min-
utes continuously in the Full Auto Mode. DO NOT OVERCHARGE THE
BATTERY. UNPLUG THE BATTERY CHARGER WHEN NOT IN USE.
Continuous battery consumption will allow the airsoft gun to shoot for 6 -8 minutes. To prolong battery
life and maintain the best shooting performance do not shoot over 5 minutes continuously in the Full Auto
Mode. For optimum performance completely use up the battery before recharging.
• Plug the charger into the battery.
• Plug the charger into a standard 110v outlet.
B. Loading the Battery
• Make sure the airsoft gun is “ON SAFE” (section 2A) and is UNLOADED.
• Point the airsoft gun in a SAFE DIRECTION.
• Remove the butt of the stock by pushing up on the release and pulling the butt off.
• Plug the battery into the battery connector.
• Insert the battery into the gun.
• Replace the butt.
C. Removing the Battery
• Make sure the airsoft gun is “ON SAFE” (section 2A) and is UNLOADED.
• Point the airsoft gun in a SAFE DIRECTION.
• Remove the butt of the stock by pushing up on the release and pulling the butt off.
• Unplug the battery from the battery connector.
• Replace the butt.
6. Using the Hop-Up Mode
Your airsoft gun is manufactured with a hop up system. The purpose
of this system is to change the spin on the BB as it leaves the muzzle,
allowing you to adapt your shot for different distances.
• Slide the Hop-up adjustment switch backward to “On”
for more spin.
• Push the Hop-Up adjustment switchforward to “Off” for less
spin. (Fig. 6)
7. Aiming and Firing Safely
• You and others with you should always wear eye protection designed for airsoft to protect your eyes.
• Always point your airsoft gun in a SAFE DIRECTION.
• Do not shoot at hard surfaces or at the surface of water. The plastic BBs may bounce off or ricochet
and hit someone or something you had not intended to hit.
• DO NOT re-use plastic BBs because they could possibly cause damage to your airsoft gun.
• Your airsoft gun is designed for target shooting and is suited for both indoor and outdoor use. Always
remember to place your target carefully. THINK about what you will hit if you miss the target.
• When you are sure of your target and backstop, and the area around the target is clear, load and
charge the airsoft gun following sections 3 and 4. Take the airsoft gun “OFF SAFE” (section 2A) aim
and pull the trigger to fire.
8. Maintaining Your Airsoft Gun
• DO NOT MODIFY OR ALTER YOUR AIRSOFT GUN. Tampering with the airsoft gun or attempts to
change the airsoft gun in any way may make it unsafe to use, may cause serious injury or death and
will void the warranty.
• If you drop your airsoft gun, visually check to see that it works properly before you use it again.
If anything seems changed, like a shorter or weaker trigger pull, this may mean parts are worn out
or broken. Call Customer Service at Crosman for assistance before using your airsoft gun again.
9. Reviewing Safety
• Do not ever point the airsoft gun at any person. Do not ever point the Airsoft gun at anything you do
not intend to shoot.
• Always treat the airsoft gun as though it is loaded and with the same respect you would a firearm.
• Always aim in a SAFE DIRECTION. Always keep the muzzle of the Airsoft gun pointed in a SAFE DI-
RECTION.
• Always keep the airsoft gun “ON SAFE” until you are ready to shoot in a SAFE DIRECTION.
• Always check to see if the airsoft gun is “ON SAFE” and unloaded when getting it from another person
or from storage.
• Always keep your finger off the trigger and out of the trigger guard until ready to shoot.
• You and others with you should always wear eye protection to protect your eyes.
• Always wear eye protection designed for airsoft over your regular glasses.
• Use 6 mm plastic BBs only.
• Do not reuse plastic BBs because they could cause possible damage to your airsoft gun.
• Do not shoot at hard surfaces or at the surface of water. The plastic BBs may bounce off or ricochet
and hit someone or something you had not intended to hit.
• Replace the backstop if it becomes worn. Place the backstop in a location that will be safe should the
backstop fail.
• Your backstop should be checked for wear before and after each use. All backstops are subject to
wear and will eventually fail. Replace your backstop if the surface is worn or damaged or if a ricochet oc-
curs.
• Do not attempt to disassemble or tamper with your airsoft gun.
• DO NOT MODIFY OR ALTER YOUR AIRSOFT GUN. Attempts to modify the airsoft gun in any way
may make your airsoft gun unsafe to use, cause serious injury or death and will void the warranty.
• Using unauthorized repair centers or modifying the function of your airsoft gun in any way may be
unsafe and will void your warranty.
• Do not put the airsoft gun away loaded. Make sure ALL of the plastic BBs are unloaded from the airsoft
gun.
• Always store this airsoft gun in a secure location.
SPECIFICATIONS
Mechanism/Action Electronic
Caliber/Ammunition 6mm Plastic BBs
Magazine Up to 500 6 mm BBs
Safety Lever
Velocity Up to 300 fps
PERFORMANCE: Many factors can affect velocity, including brand of projectile, type of projectile and
barrel condition. We recommend using only Crosman brand airsoft BBs. Use of poor quality BBs can
damage your airsoft gun.
CUSTOMER SERVICE
If your Airsoft gun is not functioning, we recommend that you call Crosman Corporation Customer Service
at 1-800-724-7486 or 585-657-6161. (International customers should contact their distributor.) DO NOT
ATTEMPT TO DISASSEMBLE IT! If you take it apart you probably will not be able to reassemble it cor-
rectly. Crosman assumes no warranty responsibility under such circumstances.
LIMITED 30 DAY WARRANTY
This product is warranted to the retail consumer for 30 days from date of retail purchase against defects in
material and workmanship and is transferable.
WHAT IS COVERED
Replacement parts and labor. Transportation charges to consumer for repaired product.
WHAT IS NOT COVERED
Transportation charges to Crosman for product. Damages caused by abuse, modification or failure to per-
form normal maintenance. Any other expense. CONSEQUENTIAL DAMAGES, INCIDENTAL DAMAGES,
OR INCIDENTAL EXPENSES, INCLUDING DAMAGE TO PROPERTY. SOME STATES DO NOT ALLOW
THE EXCLUSION OR LIMITATION OF INCIDENTAL OR CONSEQUENTIAL DAMAGES, SO THE ABOVE
LIMITATION OR EXCLUSION MAY NOT APPLY TO YOU.
WARRANTY CLAIMS
USA Customers: Attach your name, address, description of problem, phone number and copy of sales
receipt to product. Package and return to Crosman Corporation, Routes 5 & 20, East Bloomfield, NY
14443.
International Customers: Please return product to your nearest distributor. If you do not know your dis-
tributor, please call 585-657-6161 and ask for our International Department for assistance.
IMPLIED WARRANTIES
ANY IMPLIED WARRANTIES, INCLUDING THE IMPLIED WARRANTIES OF MERCHANTABILITY AND
FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED IN DURATION TO 30 DAYS FROM DATE OF
RETAIL PURCHASE. SOME STATES DO NOT ALLOW LIMITATIONS ON HOW LONG AN IMPLIED WAR-
RANTY LASTS, SO THE ABOVE LIMITATIONS MAY NOT APPLY TO YOU.
To the extent any provision of this warranty is prohibited by federal, state, or municipal law which cannot
be preempted, it shall not be applicable. This warranty gives you specific legal rights, and you may also
have other rights which vary from state to state.
CROSMAN is a registered trademark of Crosman Corporation in the United States.