User's Manual

Attach the Authenticator CF to a surface 2-9
Installation
Note Before you connect the D SCAN AUTHENTICATOR CF to the USB port of your computer
you must install the D SCAN Essentials software. The software provides the required
hardware drivers during the D SCAN AUTHENTICATOR CF installation.
You can use any USB port to plug in the D SCAN AUTHENTICATOR CF.
However, the first time you plug the device into a particular port, Windows will
install the driver for that device again.
Attach the Authenticator CF to a surface
You can attach the Authenticator CF to a flat surface like a table or counter top.
The document reader has four threaded mount points on the bottom of the case,
which are covered by the rubber feet. Use the drill template on page 2-12 to mark
the holes.
Prepare the installation
Make sure that the following conditions exist before you begin:
• The Authenticator CF is on a level surface.
• Collect the necessary pieces (drill template, four screws M4) and the tools
required for the surface you selected.
• Keep a soft cloth handy.
• Read the Authenticator CF User Manual.
Installation
To attach the Authenticator CF:
1 Put the drill template in position.
2 Mark the center of each hole.
Figure 2.8 Place the drill template