User's Manual

3-4 D S C A N
®
AUTHENTICATOR CF™ User Manual v2.1
How to use the Authenticator CF
The procedure requires usually four steps:
1 Find the data page.
2 Rotate this page in such a manner that it faces down and the MRZ (M) is
pointing left.
3 Put the page face down on the document contact area.
4 Move the document along the left part of the positioning angle until it stops.
• The accurate final position must be along the left (L) and the back (B) part of
the document positioning angle.
Figure 3.3 Positioning of a passport
Read in a document
The following section describes a complete document reading process using the
D SCAN Show Case application as an example and explains how to use the
system correctly. The operation and display of results is controlled by the software
as well as all functions.
Note The D SCAN Show Case is only part of the D SCAN Extensions SDK software package.
Depending on your used software and your station policy, the computer screens
may differ from this example. Also the status lights can be used in different
methods. However the operation of the D SCAN AUTHENTICATOR CF will
always be the same.
Note Before a document is processed ensure that the document contact area is clean. Remove
smudges, laminate glue, finger prints or other dirt that may blur the document being
processed. Avoid touching the document glass with fingers prior put on a document.
The D SCAN AUTHENTICATOR CF is very easy to use and to handle:
1 Power on the D SCAN AUTHENTICATOR CF.
2 Ensure that the ambient light cover is in the operating position.
3 Switch on your computer.
L
B
M