User's Manual

1-2 D SCAN
®
AUTHENTICATOR User Manual v1.0
Introduction
Warning A Warning describes an action that can cause injury or loss of life. Mechanical damage can occur.
DANGER A Warning describes an action or condition that causes injury or loss of life. Mechanical damage can
occur.
FCC statement
FCC ID: WO8RJ1479
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
The power source for the Authenticator must provide an output voltage of 12 V DC. The
electric current range of the power supply unit must be max. 1.7 A. Use only power supply
units that comply with the class B limits of 47 CFR 15, Subpart B.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
Information to the user
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
Industry Canada
IC: 7944A-RJ1479
This device complies with Industry Canada license-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this device may not cause interference, and (2) this
device must accept any interference, including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil
ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d'en compromettre le
fonctionnement.”
The power source for the D SCAN Authenticator must provide an output voltage of 12 V DC.
The electric current range of the power supply unit must be max. 1.7 A. Use only power
supply units that comply with the class B limits of ICES-003.
Statement of Compliance
Cross Match Technologies GmbH, hereby, declares that this device is in compliance with the
essential requirements and other relevant provisions of Directives 89/336/EEC and 2006/95/
EC.