User's Manual

2-5
Installation
This section describes how to install the D SCAN Authenticator.
Remove the contents
Note
Keep all original materials in the event you return the document reader.
Remove all the contents from the product package.
List of contents
The following items are included in the product package:
• D SCAN Authenticator document authentication reader
• External power supply unit
• Shielded and TID certified USB 2.0 A-B signal cable
Prepare to use
Make sure that the following conditions exist before you use the D SCAN Authenticator.
• After transportation or storage at low temperature, allow the reader to adjust to the
temperature at the location of operation.
• The product is on a level surface.
• The surface of the document support area is clean and dry.
• The document reader is protected from dust and humidity.
• All sharp and pointed objects are kept away from the document support area surface.
Connect the Authenticator
The connectors are at the back of the device. Use the following procedure to install the Authenticator
power and USB cables. The procedure applies to desktop and laptop computers.
1 Put the device on a clean flat area like a table.
2 Get the USB and power cables.
Note
Before you connect the power cable make sure that the power switch ( 3 ) is in the OFF position.
3 Connect the power cable (1). The flat part (1a) of the cable connector must point to the top for the
correct orientation.