User's Manual

2-6 D SCAN
®
AUTHENTICATOR User Manual v1.0
.
Figure 2.5 D SCAN Authenticator connectors
4
Connect the USB 2.0 cable (2). Use only a shielded and TID certified cable.
.
Figure 2.6 USB certification labels
5
Connect the power supply to the AC electrical outlet.
Note
Before you connect the D SCAN Authenticator to the USB port of your computer you must install
the D SCAN Essentials software. The software provides the required hardware drivers during the D
SCAN Authenticator installation.
6 Connect the other end of the USB cable to the USB 2.0 port of your computer.
7 Turn the power switch (3) to the ON position. The integrated LED lights green.
.
Figure 2.7 Power switch
8
You have completed the procedure.
You can use any USB port to plug in the Authenticator. However, the first time you plug the device
into a particular port, Windows will install the driver for that device again.
Note
Use a portable computer with external power supply only. It guarantees that the voltage of the
USB port is not less than 5 V DC.
1a
12
3
ONOFF