User's Manual

2-8 D SCAN
®
AUTHENTICATOR User Manual v1.0
Background correction images created during manufacturing are stored on the Authenticator.
However they will be stored automatically on the connected computer during the boot process. Each
set of background correction images stored on the computer is overwritten with the new one when:
• You connect a new Authenticator or one returned from service.
• You replace the computer connected to the Authenticator.
Also during the boot procedure of the Authenticator a self-calibration of the device is processed. The
complete boot process takes up to one minute.
Attach the Authenticator to a surface
You can attach the Authenticator to a flat surface like a table or counter top. The document reader has
four threaded mount points on the bottom of the case. Use the drill template on page -11 to mark the
holes.
Prepare the installation
Make sure that the following conditions exist before you begin:
• The Authenticator is on a level surface.
• You collect the necessary pieces (drill template, four screws M4) and the tools required for the
surface you selected.
• You read the Authenticator User Manual.
Installation
To attach the Authenticator:
1 Put the drill template in position.
2 Mark the center of each hole.
Figure 2.9 Place the drill template
3
Remove the drill template and make four holes.
4 Put the Authenticator above the holes.