User's Manual

3-4 D SCAN
®
AUTHENTICATOR User Manual v1.0
Smart cards
The smart card reader is an optional feature. The corresponding slot is on the right top. It is the shorter
slot (3) and is labeled with an icon.
1 Grasp the smart card so that the chip of the card faces to the outside.
2 Move the smart card in the slot at an angle of 45 degrees until it stops.
Figure 3.3 Insert a smart card
Magnetic stripe cards
The magnetic stripe card reader is an optional feature. The corresponding slot is on the right top. It is
the larger slot (4) and labeled with an icon.
1 Hold the magnetic stripe card so that the magnetic stripe points down and faces away from the
Authenticator.
2 Insert the card from the back into the slot.
3 Move the card through the slot until it is free.
Figure 3.4 Placing a magnetic stripe card
Read in a document
The following section describes a complete document reading process using the D SCAN Show Case
application as an example and explains how to use the system correctly. The operation and display of
results is controlled by the software as well as all functions.
Note
The D SCAN Show Case is only part of the D SCAN Extensions SDK software package.
Depending on your used software and your station policy, the computer screens may differ from this
example. Also the status lights can be used differently. However the operation of the D SCAN
Authenticator is the same.
Note
Before a document is processed make sure that the document support area is clean. Remove
smudges, laminate glue, finger prints or other dirt that may blur the document being processed.
Avoid touching the document glass with fingers prior to use.
45°
3
4