User's Manual

3-5
The D SCAN Authenticator is easy to use:
1 Turn on the D SCAN Authenticator.
2 Turn on your computer.
3 Start the D SCAN Show Case application. The software initializes the D SCAN Authenticator and
switches it to the Ready to scan mode.
• Depending on the performance of your computer, start-up can take a few moments.
Figure 3.5 Launching application
• After successful initialization the Overview window appears. The green status light (1) is on and
indicates the Ready to scan mode.
The Overview page
The Overview page is the default page that shows the data from the processed document. Use the
Tabs at the top to navigate and to view all data and images.
1 Put the data page of the document to be read face down on the document support area.
Warning
Do not look directly into the lights of the document support area. Maintain a required minimum
distance of not less than 11.8 inches (0.3 m).
2 A short acoustic signal indicates that the document is in the correct position. The processing starts
automatically.
• A processing bar (2) is shown at the bottom and the Image processing lights (3) are on. The
image processing lights indicate that the data are recorded and processing is started.
• If RFID data are available the Reading RFID lights (4) are on and processing is started.
Figure 3.6 Processing information
Note
Do not move the document until the yellow processing light turns off.
• When the document reader completes processing the document, the processing lights turn off,
the green Ready to scan light comes on and a short acoustic signal occurs.
• You can remove the document.
1
2
3 4