Owner's Manual

1. NO SOUND

• Check the “POWER” switch on the Receiver/Speaker. RIGHT is ON and LEFT is OFF.

• Receiver/Speaker, the slide switch must be in "RUN" position.

• Check and turn up the volume control knob of the Receiver/Speaker.

• Check the AC adapter. It must be properly connected to the Receiver/Speaker

and an active wall receptacle.

• A message must have been recorded.

• Test the message by pushing the appropriate message button located on the

Receiver/Speaker.

• A Sensor/Transmitter must have been programmed to activate the voice message.

If the program of the Receiver/Speaker gets deleted, you must follow the instructions in

Section VI • PROGRAM ONE OR MORE SENSOR/TRANSMITTERS.

2. THE SENSOR/TRANSMITTER WILL NOT OPERATE Voice Alert™

• Check the Sensor/Transmitter 9 volt battery.

• Check the power connection to the Receiver/Speaker.

• Follow the steps in Section VIII • SENSOR /TRANSMITTER INSTALLATION above.

• Make sure the steps in Section VI • PROGRAM ONE OR MORE SENSOR/TRANSMITTERS,

have been followed. Step 3 is very important. If the Receiver/Speaker “SET UP” LED

does not glow, the Sensor/Transmitter did not get programmed and the

procedure will have to be repeated.

3. POOR DISTANCE

• Check the Sensor/Transmitter battery.

• Check the Receiver/Speaker DC power source.

• Check the Receiver/Speaker with a different Sensor/Transmitter.

• Check that the Sensor/Transmitter is not fastened to metal.

• Move the Receiver/Speaker about 1 foot in any direction.

4. CANNOT RECORD A MESSAGE

• Turn on Receiver/Speaker power.

• Turn the Volume Control up.

• Make sure the slide switch of the Receiver/Speaker is in "RECORD" position.