Technical Manual

Technical Manual AM Systems
Configuration v4.4 Page 39 of 72
7 Configuration
This chapter describes the recommended adjustment procedure for the AM transceiver
and receiver.
7.1 General connections
x Refer to chapter 3.1 (page 9) for noise sources and installation guidelines.
x Position the antenna(s) at the required location.
x Connect the power supply to the power input of the TRX board
x Connect the FTP cable between the RX and TRX board (in case of a multiple
antenna setup)
x Connect the receiver cable between the RX and TRX board (in case of a multiple
antenna setup)
x Switch on the power supply → the power LED’s on both the TRX and RX will light
up.
x Wait for about 10 seconds for the system to start up.
7.2 TRX configuration settings
Although the TRX comes pre-configured with factory settings, it can be necessary to fine-
tune this board for best performance in your specific environment.
The TRX can be configured through the Field Bus using a host computer and the Cross
Point Device Explorer software.
7.3 TRX configuration – Device Explorer
Please refer to chapter 8.7.5.1 for further details on how to configure the TRX using the
Device Explorer software.