Technical Manual

Technical Manual AM Systems
Cross Point Device Explorer v4.4 Page 49 of 72
The aisle width for each aisle can be specified. By default the value is set to 160cm, but
can be changed to the actual value by clicking on the aisle width en entering the correct
value. In case all aisles in this entrance have the same aisle width, just enter the value for
one aisle and then click the chain button to change all aisles to the same aisle
width.
The backfield of a AM transceiver can be enabled or disabled by clicking on the waves at
the backside of the transceiver.
Figure 37: Enabling or disabling backfield detection
Entrance or passage? 8.7.3.4.1
When the entrance is set as an ‘entrance’, visitor counting numbers will be added to the
total number of visitors included in the visitor counting report. Select the option ‘Passage’
in case the visitor counting numbers of this specific entrance should not be added to the
total visitor counting.
Reverse view direction 8.7.3.5
By default the 3D-view shows the entrance from the outside looking into the store. This
view can be reversed (looking outside from within the store) by clicking the Reverse view
button. This does not change the actual counting direction!
Backfield enabled
Backfield disabled