Technical Manual

Technical Manual AM Systems
Cross Point Device Explorer v4.4 Page 50 of 72
8.7.4 Entrances – selected entrance
When an entrance is selected in the Main menu and the Home button in the button bar is
pressed, the bottom part of the screen will show the following tabs:
Notifications 8.7.4.1
In case of an alarm situation, notifications will be used to draw attention and to present
information about the type of alarm.
Notifications can be set for each entrance individually, when different notifications per
entrance are required, or you can set the notifications for all entrances at once. To do
this, go to System and specify the required notification settings. See section 8.8 for more
details.
Figure 38: Entrance notification settings
Entrance notification settings apply to all antennas that are part of the
selected entrance. It is not possible to create different individual
notif
ication settings within the same entrance!
The following notification types can be selected by clicking on the cell in the top left
corner of the notifications table:
x Alarms
x Metal
x Visitors
x Other
Select notification type here
Pre-defined notifications