Technical Manual

Technical Manual AM Systems
Cross Point Device Explorer v4.4 Page 51 of 72
Alarms 8.7.4.1.1
Notification
Explanation
Tag detected
This notification can be used as a ‘pre
-
alarm’ feature when the
option “Use visitor counter to distinguish in
-
and outgoing
alarms” has been enabled.
In case the option “Use visitor counter to distinguish in
-
and
outgoing alarms” is disabled (so no detection of incoming and
outgoing alarms), this notification must be used as the general
alarm setting.
Outgoing
*
Notification setting for outgoing alarms*
Incoming*
Notification setting for incoming alarms*
Undefined/Ghost
*
Notification setting for alarms where the direction could not be
determined*
Table 5: Alarm notifications
* depends on setting “Use counter to determine direction”
Visitors 8.7.4.1.2
Notification
Explanation
Incoming visitor
When a visitor enters the store, a ‘door bell’
notification can be
triggered to notify employees in the store that a visitor has just
entered the store.
Outgoing visitor
When a visitor leaves the store, a ‘door bell’ notification can be
triggered to notify employees in the store that a visitor just left
the store.
Visitor counter blocked
When the infra
-
red beam of the visitor counter is blocked for a
specific minimum amount of time (default 30 seconds), a
counter blocked notification can be triggered to notify visitors
and employees in the store
that there is an aisle blockage.
NOTE: The wait time before visitor counter blocked can be
adjusted to another value if required. Just specify a value
between 1 and 3600 seconds.
Table 6: Visitor counter notifications