Technical Manual

Technical Manual AM Systems
Cross Point Device Explorer v4.4 Page 58 of 72
We now have two ways of synchronizing the systems; manually or automatically.
Manual synchronization
By default the transmission burst can be synchronized manually by dragging and moving
the burst throughout the complete 20ms time base.
Just hover the mouse cursor over our transmission burst (the cursor will change to a
horizontal double arrow) and press down your left mouse button. While keeping the
mouse button pressed, move the transmission burst and position it on top of the other
system’s transmission burst. Together with moving the transmission burst, also the
receiver and reference windows will move automatically since they have a fixed reference
to the transmission burst.
Automatic synchronization
It is also possible to let the software detect the best position for the transmission burst.
Just click the Automatic Sync button and within 10 to 15 seconds the software will have
determined the best burst offset position.
Figure 44: Synchronization AM – correct adjustment
Figure 44 shows our system being properly synchronized with the other system’s
transmission burst. Our transmission burst is on top of the other system’s transmission
burst and both our receiver and reference windows are not on top of any other
transmission bursts.
Our system’s
receiver window
(red bar)
Our system’s
transmission burst
(orange bar)
Our system’s
reference
window
(green
bar)
Other system’s
transmission bursts
(blue curve)