Technical Manual

Technical Manual AM Systems
Cross Point Device Explorer v4.4 Page 61 of 72
Notifications – I/O settings 8.7.5.2.3
Next to the audio and visual alarm notifications, as described in section 8.7.4.1, also a
relay and a maximum of 2 I/O’s can be programmed to activate any external device
(camera, external buzzer, etc.) during an alarm situation.
These notification settings have to be programmed on each individual antenna, since the
relay and I/O’s are antenna specific. Any externally connected device needs to be
physically connected to the antenna.
Figure 46: Notifications – I/O settings
Relay and I/O notification settings apply only to an individual antenna!
The following notification types can be selected by clicking on the cell in the top left
corner of the notifications table:
x Alarms
x Metal
x Visitors
x Other
Refer to section 8.7.4.1 to view all available notification types.