Technical Manual

Technical Manual AM Systems
Cross Point Device Explorer v4.4 Page 68 of 72
8.8.4 Devices
The Devices screen shows a list of all connected devices, their firmware status and some
system settings.
Figure 54: System – Devices
In the Devices list it is possible to:
x View the firmware version of each connected device
x Upload new device firmware
x Locate an individual device or all devices at once
x Reset an individual device or all devices at once
x Remove disconnected device(s)
Just hover over a device and the Locate and Reset buttons will appear.
Locating a device 8.8.4.1
Press the Locate button once to activate the buzzer and LEDs on the selected device.
The Locate icon will start blinking and will keep on blinking. Press the Locate button again
to stop locating the selected device.
Resetting a device 8.8.4.2
Press the Reset button to reset only the selected device.
Uploading new firmware 8.8.4.3
In case new firmware is available, you can automatically upgrade all devices of the same
type by pressing the Update all button .