Technical Manual

Technical Manual AM Systems
Cross Point Device Explorer v4.4 Page 69 of 72
Removing disconnected devices 8.8.4.4
All devices that have the disconnected status can be removed permanently by pressing
the Remove disconnected devices button .
Turning all LEDs on/off 8.8.4.5
The LEDs on all connected devices can be switched on at once by pressing the Turn all
LEDs on button . This is useful to check whether all devices are connected, especially
in large installation. Press this button again to switch all LEDs off again.
Resetting all connected devices 8.8.4.6
Press the Reset all button to reset all connected devices at once.