Technical Manual

Technical Manual
ARGUS AM Floor System
Cross Point Device Explorer v1.2 Page 57 of 65
Notifications – I/O settings
Next to the audio and visual alarm notifications, as described in section 13.5.4, also a relay
can be programmed to activate any external device (camera, external buzzer, etc.) during
an alarm situation. The available input can be used to connect an external pushbutton to
enable the Forced Alarm option.
These notification settings have to be programmed on each individual Control Unit, since
the relay and input are device specific. Any externally connected device needs to be
physically connected to the Control Unit.
Figure 56: Input and relay settings
Input and relay notification settings apply only to an individual Control
Unit!
The following notification types can be selected by clicking on the cell in the top left corner
of the notifications table:
• Tag
• Other
Refer to section 13.5.4 to view all available notification types.