User Manual

MPR/MIB User’s Manual
Wireless Sensor Networks
Doc. # 7430-0021-06 Rev. A Page 47
Table 14-6. Controls, Indicators, and Connector Summary.
ID NAME DESCRIPTION
CONTROLS
SW1
RESET MIB600 Manual RESET pushbutton. Resets MIB600 ISP controller and attached MOTE.
SW2
POWER
SELECT
5V Selects External 5VDC power source at J7
POE Selects Power Over Ethernet provided at RJ45/J10
Serial Server
Reset
Reset Serial Server. Located on Server sub module U15
CONNECTORS
J1 MOTE I/O 51 Standard 51 Position MICAx-series Mote interface
J7
External 5VDC
Input
Connects to external 5VDC +/-20% power supply
J9 JTAG-ISP JTAG connection to MIB600 ISP Controller. For Factory Test only
J10 RJ45 / LAN Ethernet 10Base-T connection (w/ IEEE 802.3af option)
J11 MOTE Umbilical
Umbilical connection to Mote Adapter PCB. Used for connection to MICA2 and
MICA2DOT motes.
J12 JTAG-MOTE
JTAG connection to attached MICA2/MICA2DOT Mote. Provides JTAG connectivity
between external JTAG pod and Mote.
COM1 Factory use only. Do not use
INDICATORS
D2 MOTE-YELLOW Corresponds to attached Mote’s Yellow LED
D4 MOTE-RED Corresponds to attached Mote’s Red LED
D7 MOTE-GREEN Corresponds to attached Mote’s Green LED
D3 ISP Active Indicates MIB600 in PROGRAMMING mode – RED
D5 Power OK Indicated MIB600 input power is OK
Table 14-7. J12 Mote JTAG
PIN NAME DESCRIPTION
1 TCK/ADC4 MICA2(DOT) JTAG Clock
2 GND Ground
3 TDO MICA2(DOT) JTAG Data Out
4 VCC 3.3V Power
5 TMS MICA2 (DOT) JTAG Sync
6 RSTN MICA2 (DOT) Reset
7 VCC 3.3V Power to JTAG Pod
8 N/C Not connected
9 TDI MICA2(DOT) JTAG Data In
10 GND Ground