Installation Guide

- Vinyl Tile - Vinyl Asbestos
- Asphalt Tile - Linoleum
- Rubber Tile - Concrete
- Flagstone - Terrazzo
- Ceramic Tile
GENERAL PRODUCT INFORMATION
FOR USE
AVAILABLILITY
CK223-1 55 GAL
CK223-2 5 GAL
CK223-4 4/ 1 GAL
CK223-5 12/ 32oz Bottle
SAFETY INFORMATION
Avoid contact with eyes, skin and clothing. Wear
protective eyewear, gloves and footwear when
handling. Avoid breathing of vapors. Keep out of
reach of children. For use by trained personnel only.
Keep unauthorized personnel away when applying
to floor. Keep container closed during storage. For
institutional and industrial use only.
Refer to product Material Safety Data Sheet (MSDS)
prior to product use.
For chemical emergency only, call Chemtrec 1- 800-
424-9300
CROSSHINE
DIRECTIONS
PREPARATION: If stripping is necessary, use
CROSSCO WAXEX stripper and follow directions
accordingly.
If floor is in good condition and stripping is not
necessary, sweep up excess dirt and dust and then
clean with a good quality cleaner to remove dirt and
oils. Follow with a thorough rinsing and allow to
dry completely.
FINISHING: Spread a liberal coat of finish evenly
across the floor with a clean mop or applicator.
Allow each coat to dry at least 30 minutes before
applying the next coat. Two or three coats are
desired initially, depending on the condition of the
floor and gloss desired.
MAINTENANCE: The floor may be maintained using
a quality floor cleaner and damp mopping regularly.
Spray buffing or mop-on restoring may also be
done after sweeping up loose dirt and dust. Follow
directions for each product accordingly.
Notice: The technical data contained herein are true
and accurate to the best of our knowledge.
Published instructions are subject to change
without prior notice.