Instruction manual

Hallett 15xs Instruction Manual

Voltage Surge Suppressor into a grounded electrical outlet. Flip the switch on the

Transient Voltage Surge Suppressor to ON position.

Installation is now complete.

Important: after the unit has been operating for a few hours, unplug the unit and

check all hose connections for leaks (the top hose in particular). Repeat this

procedure periodically.

Proceed to system operation for further instruction to ensure optimal

performance.

Flushing Instructions

Flushing the system is required after installation or after any disassembly and

cleaning. Flushing may also be required to remove colored water from the unit.

Most filters (if installed) also require flushing prior to use – follow the

manufacturer’s recommendations.

The system may be flushed in two ways. It can be done manually by

disassembling the unit and filling and draining the unit by hand (see Cleaning the

Unit). Flushing may also be done while the unit is operating. Plug in the unit and

open a faucet closest to the unit and run the water for a minimum of 15 minutes.

Control Interfaces

Remote Wireless Monitor (optional)

The Hallett system is available with a remote monitor that monitors the system

operation and alerts you to any change in status. If the unit did not come with a

Remote Monitor, the main unit will display “Radio Initialize Problem” or “Radio

Device Not Installed” upon start up – please ignore this message. If the unit is

equipped with a Remote monitor, install the 9v battery (included) in the remote

monitor and place the monitor in a location of your choice. The remote will

operate up to 164 feet (50m) from the Hallett system location, (Please note that

masonry walls decrease the distance the remote can communicate with the

Hallett system). The remote will run through a diagnostic and then sync with

your Hallett system and display a message indicating unit status. If a warning or

alarm is displayed, detailed information will be available at main unit. If the

remote loses communication with the Hallett, it will display “No Sync”. Move the

monitor to a different location until communication has been reestablished.

The radio frequency used by the remote is 2.4GHz and has FCC modular

approval grant to meet FCC Part15, EN300 328-1, EN301 489-1, Industry

Canada RSS-211.

Setup procedure

Step 1: Using the Setup Menu on the main UV Pure unit, select “Bind Remote

Device” and choose a bind number (This is a number from 0 to 40 to differentiate