Instruction manual

Hallett 15xs Instruction Manual

screwdriver (counterclockwise while looking at the shaft).

MOTOR

PURGE VALVE

THERMISTOR

WIRES

CUT WIRE TIE WRAP

WHEN NECESSARY

REMOVE & SUPPORT

TOP QUARTZ

SEAL ASSEMBLY

DISCONNECT 1/4"

PURGE VALVE DRAIN

REMOVE WIPER ASSY. BY

ROTATING IT COUNTER-

CLOCKWISE AS YOU LIFT

DISCONNECT

FLEX. HOSE

Figure 4C

Step 8: Drain the unit and inspect the quartz sleeve. If clean, flush the unit with

clean water. If fouling remains, repeat procedure.

Step 9: Once the unit is clean, reassemble the unit including the motor and top

hose connection.

Step 10: Slowly open the water supply and check for leaks.

Step 11: Replace all covers and plug in the Hallett unit.

Disassembling the Unit

NOTE: This procedure is not recommended for individual household users

please contact your certified water specialist to assist should disassembly be

required.

Step 1: Fill a bucket or container with water before shutting off the water supply

since you will need the water later to clean the quartz sleeve (11). A squeeze

bottle is useful for applying water or cleaning solution to the inside of the quartz

sleeve.

Step 2: Place another bucket under the unit and drain the unit (see Draining the

Unit).

Step 3: Open the front panel. The lamps may be removed to prevent them from

getting dirty or damaged.

Step 4: Disconnect the Stainless flexible hose (8) from the top of the unit and

remove the top quartz seal assembly.

Caution: Do not damage the sealing surfaces of the end caps (5 and 19) or the