Instruction manual

Hallett 15xs Instruction Manual

shaft of the wiper assembly (12). Handle these parts with care to prevent water

leaks.

REMOVE BOTTOM

QUARTZ SEAL ASSY.

REMOVE COVER:

PULL OUTWARDS

AND DOWN

REMOVE BOTTOM

O-RING

DISCONNECT

FLEX. HOSE

REMOVE & SUPPORT

TOP QUARTZ

SEAL ASSEMBLY

REMOVE TOP

O-RING

LIFT QUARTZ SLEEVE

OUT OF THE UNIT

Figure 4D

Use the 7/16” (11mm) wrench to remove the four nuts in an alternating pattern

(top left, bottom right, bottom left, then top right). The bottom quartz seal

assembly does not require removal to clean the quartz, so leave it in place. This

will support the quartz sleeve during cleaning and simplify the overall process.

Step 5: Remove the top quartz seal assembly (FIG. 4C) by lifting it straight up.

The wires are bundled together using a tie wrap. If you require more room to lift

the top quartz seal assembly, cut the tie wrap to give you more freedom to lift the

assembly over the wiper shaft.

Step 6: Remove the wiper assembly (12) by carefully lifting it up and out of the

quartz sleeve. Rotating it as you lift will help. Caution: the wiper blades are

sharp, handle them with care.