Instruction manual

Hallett 15xs Instruction Manual
Released on 20-Sept-12 – H800003P Page 40 UV Pure Technologies Inc. © 2012
Step 3: Tighten the nuts in an alternating pattern. Bundle the wires if necessary.
Step 4: Reconnect the flexible hoses (8), both top and bottom. Close the front
panel.
Step 5: Close any faucets and open the water supply. Inspect for leaks. The
solenoid valve (optional) can be placed into manual mode to allow water to enter
the unit. Switch back to automatic mode when done. Repair any leaks if
necessary. Caution: Do not operate the unit if there are any leaks at the piping
connections or within the unit.
Step 6: Replace the lamps.
Step 7: Reinstall the top and bottom covers.
Step 8: Plug in the unit.
Step 9: Make an entry in the service record to establish a cleaning schedule.
HOLE ON END
OF WIPER SHAFT
MUST BE ON TOP
ALIGN HOLE IN
SHAFT ADAPTER
WITH THE
WIPER SHAFT
Replacement Parts
Use only genuine UV Pure parts when servicing your Hallett. Figure 4B shows a
complete list
Replacement parts and Service are available from your Installer or a Certified
Service Dealer (CSD). A complete list of Certified Service Dealers and their
coverage areas is available on UV Pure’s website: uvpure.com.
Manufactured by: UV Pure Technologies Inc.
60 Venture Drive, Unit 5
Toronto, Ontario, Canada
M1B 3S4
416-208-9884, 1-888-407-9997
FAX [phone]
e-mail inquires: [e-mail]
www.uvpure.com
Date of Purchase:
Figure 4E