Instruction manual

Hallett 13 & 30 Instruction Manual - Wastewater & Reuse

management depot or transfer station; contact your local recycling and waste

management authority for proper disposal procedures in your area.

If one or both lamps exhibit significant discoloration at their ends, this

implies the lamps and ballast have expired. Both lamps and ballast must be

replaced. Operating new lamps with an expired ballast will cause damage

to the new lamps.

Step 4: Install the new lamps into the unit, being careful not to touch the bulb.

Ensure that the lamps are aligned with the “Stop Sign” printed on the top

ceramic facing inward (towards quartz sleeve). If you can see the stop sign,

the lamps are backward (See Figure 3).

WHILE PINS ARE ENGAGED

DO NOT TWIST / TURN THE LAMPS

BOTTOM VIEW

www.uvpure.com

FACES OUT FACES IN

Figure 3

Once the pins of the lamp begin to engage into the lamp socket, push firmly

down on the top of the lamp. Do not twist the lamps when they are inserted.

The lamp will come to rest when the pins are fully seated into the socket. When

pressing down, be sure to position the lamp ceramic end in the centre of the hole

in the aluminum top plate. Repeat this for the other side.

Step 5: Replace the top cover and screw. Note that the slots on the either side of

the top cover must align with the top wall bracket.

Step 6: Record the date of the lamp replacement in your Service Record Sheet.

Step 7: Plug in the unit.