Instruction manual

Hallett 13 & 30 Instruction Manual - Wastewater & Reuse
Released on 1-May-14 – XH115B Page 30 UV Pure Technologies Inc. © 2014
19
Seal Washer for SS Hose – sold in
pairs
2 E500019 C500009 C500010
20
Rubber Washer – Motor Shaft
(Included in Motor Kit)
1 N/A
21
Foam Pad for Motor (Included in
Motor Kit)
1 N/A
22
Bottom Bracket Assy c/w Lamp
Wire Harness
1 E300183 C300068
23
Bottom End Cap Assy – Motor End
c/w Seals
1 E300178 C300078 C300086
24
Quartz O ring seal (included in
Quartz Kit or Seal Kit)
2 N/A
25
Wiper O ring Seal (included in Seal
Kit)
1 N/A
26
Washer, Teflon 5/8” ID x 1” OD
(included in Seal Kit)
1 N/A
26A
Plastic Washer (included in Wiper
AssemblyKit)
1 N/A
27
U Cup Seal for Wiper (included in
Seal Kit)
1 N/A
28
Solenoid Shut-off Valve (Normally
Closed) (Optional)
1 550054 550055 550056
29 Display Pad (Membrane switch) 1 E100016
30 Purge Valve Assembly 1 X500000
31 Cold Air Kit 1 X500001
32
Replacement Fuse Pack for 120V
units (6 in pack)
1 E400020
33
Replacement Fuse Pack for 240V
units (6 in pack)
1 E400021
34
Transient Voltage Surge
Suppressor for 115V systems
1 150207
35 Circuit board – Waste Water 1 E100073
36 Hallett Diagnostic Tool 1 X100012
*Older generation Hallett 30s used semi-circular reflector panels similar to Hallett
13 – to reorder these panels, use p/n E300084T
Cleaning/Removing the Quartz Sleeve
Note that numbers in parentheses refer to Figure 4B.
Step 1: Use a bottle cleaning brush with a long handle to scrub the inside of the
quartz sleeve. Scrub and flush with clean water repeatedly to clean the quartz.
Use a squeeze bottle to apply water or solution to the quartz sleeve to keep the
area tidy. Note: Keep the rest of the unit free from moisture. Examine the
quartz by looking through the unit.
Step 2: If the quartz is still dirty, use a scale remover such as CLR or Lime Away
and apply it to the inside of the quartz sleeve. Citric acid, available at a drug
store, can also be used. Always flush with clean water afterwards.
Step 3: Once the quartz is clean, reassemble the unit (see below). Replace any
seals that appear to have been damaged.
Step 4: If the quartz is still not clean, it requires replacement. This is done by
removing the bottom quartz seal assembly.