User's Manual

CrossFire HP – All-Digital Transport System
User Guide
© SUNWAVE COMMUNICATIONS LIMITED 2015 21 Revision 05
Figure 2-2 Web Browser OMT Connection for Wired Access
2.2.2. Wired Access to the OMT on the Slave AU, EU and RU
In the CrossFire system, EUs and RUs, as well as the Slave AUs, are defined as slaves. They have no fixed IP address.
The IP addresses are assigned by the host automatically, based on the network topology.
To set up wired access to the OMT, use the following procedure:
1. Connect a PC to the “CONSOLE” port on the front panel of the Slave device with a network cable.
2. Change the TCP/IP properties (see Figure 2-3):
a) Click Network Connections
b) Click Local Area Connection Properties
c) Click TCP/IP Properties
d) Select the General tab
e) Change the following parameters as indicated:
a. Enable Obtain an IP address automatically by clicking the check box
b. Enable Obtain DNS server address automatically by clicking the check box
3. Check the status of the Local Area Connection and confirm the connection is connected.
4. Open a browser window and enter the default gateway in the navigation bar. This will access the WebOMT
page.