User's Manual

CrossFire HP – All-Digital Transport System
User Guide
© SUNWAVE COMMUNICATIONS LIMITED 2015 23 Revision 05
2.2.3. Wireless Access (for AU and EU)
Figure 2-4 shows the equipment required for wireless access to the OMT.
WLAN Network Adapter (
SUNWAVE-specified only) PC with wireless connection function
Figure 2-4 Equipment Required for Wireless Access to the OMT
To set up wireless access to the OMT, use the following procedure:
1. Plug the WLAN Network Adapter into the “AP” port of the device (Only AU & EU support).
2. Confirm that the adapter is working by checking that the green indicator is flashing.
3. Change the TCP/IP properties (see Figure 2-5):
a) Click Network Connections
b) Click Wireless Network Connection
c) Click TCP/IP Properties
d) Select the General tab
e) Change the following parameters as indicated:
a. Enable Obtain an IP address automatically by clicking the check box
b. Enable Obtain DNS server address automatically by clicking the check box
4. Choose the correct wireless network and connect to it.
 The naming rule for the network is CrossFire-XX (device type)-XXX (Serial Number).
 The default network key is 12345678.
 See Figure 2-6 and Figure 2-7 for details.
5. Check the wireless network status and obtain the default gateway. See Figure 2-8 for details.