User's Manual

CrossFire HP – All-Digital Transport System
User Guide
© SUNWAVE COMMUNICATIONS LIMITED 2015 26 Revision 05
Figure 2-8 Checking the Wireless Network Status
Figure 2-9 Connecting to WebOMT
2.2.4. USB Access
To set up USB access to the OMT, use the following procedure:
1. Connect a PC to the “Debug” port on the front panel of the device with a USB-to-USB cable.
Note: The USB-to-Ethernet drive should be installed in the connected PC. Contact
SUNWAVE if you have any
problems with this.
2. Check the status of the Local Area Connection and confirm the connection was successful.
3. Open a browser window and enter default gateway in the navigation bar. This will access the WebOMT page.