User's Manual

CrossFire HP – All-Digital Transport System
User Guide
© SUNWAVE COMMUNICATIONS LIMITED 2015 38 Revision 05
Figure 3-6 Master / Slave AU Selection
After setup is complete, check the device type of the AU.
To query the device type:
1. Log in to the Slave AU WebOMT. (See Section 0 for the procedures to access the OMT.)
2. View the Site Info field. See 3 in Figure 3-6.
3. The device type should be “Slave AU” if the setup was successful.
Note: Please update the day and time after a Slave AU changes to a Master AU.
3.7. OMT Parameters, Alarms and Commands for the AU
See Section 2.3, OMT Display, for information on how to use the WebOMT interface to view and change parameters
s and run commands.
3.7.1. AU User and Network Parameters
Table 5, Table 6 and Table 7 show the device information, TCP/IP and SNMP network management parameters,
s, respectively, that are displayed on the WebOMT under the User Parameters tab.