User's Manual

CrossFire HP – All-Digital Transport System
User Guide
© SUNWAVE COMMUNICATIONS LIMITED 2015 42 Revision 05
Table 10 AU Sampling Info
Parameter
Description
RD/RW
Over-temperature Threshold
Default value:80℃/ Range: -55~ +125℃
RW
Device Temperature
/
RD
Device Routing Addr
Device routing address
RD
3.7.4. AU Band Config
Table 11 Channel 1~4
CH1 Info Check
Valid: Channel operating normally
Invalid: out of operation
RD
UL Freq_low
Lower limit of uplink frequency
RW
UL Freq_high
Higher limit of uplink frequency
RW
DL Freq_low
/
RW
DL Freq_high
/
RW
Signal1~3 Bandwidth
/
RW
Signal1~3 UL Center Frequency
/
RW
Signal1~3 DL Center Frequency
/
RW
Note: UL Freq_low/high and DL Freq_low/high should agree with the values for the corresponding duplexer.
The values for signal bandwidth and UL/DL center frequency should agree with the operators’ signal.
Table 12 AU Public Parameters
Parameter
Description
RD/RW
AU CH Info Update
Update after channel parameter configuration. Configuration
modification will be effective after update.
RW
Local Signal Bandwidth
Signal bandwidth of local AU
RD
Local Transmission Bandwidth
Transmission bandwidth of local AU
RD
System Signal Bandwidth
Signal bandwidth of all AUs if Slave AU exists
RD
System Transmission Bandwidth
Transmission bandwidth of all AUs if Slave AU exists
RD
Note: See Section 7.2 for details on configuring channel properties.
3.7.5. AU Digital Info
Table 13 AU Downlink Power
Parameter
Description
RD/RW
CH1~4 DL Baseband Input-power
Power of DL detected in digital domain
RD
Table 14 AU Uplink Power
Parameter
Description
RD/RW
CH1~4 UL Baseband Output-power
Power of UL detected in digital domain
RD