User's Manual

CrossFire HP – All-Digital Transport System
User Guide
© SUNWAVE COMMUNICATIONS LIMITED 2015 48 Revision 05
Parameter
Description
RD/RW
Device Temperature
/
RD
Device Routing Addr
Device Routing Address
RD
4.5.4. EU Engineering Information
Table 28 EU Engineering Info
Parameter
Description
RD/RW
Update Time
Last update time
RD
ARM CRC Check
To check ARM software CRC value of current device
RD
FPGA CRC Check
To check FPGA software CRC value of current device
RD
EU CRC Check
To check EU software CRC value of current device
RD
Table 29 EU: OP Info
OP1~6 CPRI Sync Alarm
CPRI SYNC Alarm of Port “ OP1~OP6”
RD
OP-slave CPRI Sync Alarm
CPRI SYNC Alarm of Port “ SLAVE”
RD
OP-master CPRI Sync Alarm
CPRI SYNC Alarm of Port “ MASTER”
RD
OP1~6LOS Alarm
Loss of optical signal Alarm of Port “OP1~OP6”
RD
OP-slave LOS Alarm
Loss of optical signal Alarm of Port “Slave”
RD
OP-master LOS Alarm
Loss of optical signal Alarm of Port “Master”
RD
Table 30 AU Advanced Commands
Command
Description
RD/RW
Hardware Reset
Noted：Signal interruption during hardware reset
RW
Software Reset
Noted：Signal is normal during software reset
RW
Wi-Fi Module Reset
/
RW
Initialization/Alarm Report
Initialization: Clear alarms and disable all alarms;
Report Site launch: Report to OMC when new site launches;
RW
Alarm Mode Selection
Normal mode: 3 minutes
Test mode: 1 minute
RW
4.5.5. EU Digital Info
Table 31 Optical Module Information
Optical Port 1 Optical Module
/
RD
DDM Function Availability
/
RD
Tx Power
/
RD
Rx Power
/
RD
Voltage
/
RD