User's Manual

CrossFire HP – All-Digital Transport System
User Guide
© SUNWAVE COMMUNICATIONS LIMITED 2015 55 Revision 05
Table 47 RU: OP Info
OP-slave CPRI Sync Alarm
CPRI SYNC Alarm of Port “ Slave”
RD
OP-master CPRI Sync Alarm
CPRI SYNC Alarm of Port “ Master”
RD
OP-slave LOS Alarm
Loss of optical signal Alarm of Port “Slave”
RD
OP-master LOS Alarm
Loss of optical signal Alarm of Port “Master”
RD
Table 48 RU Channel Map (RU-AU)
Channel Map 1
See below for details
RD
Channel Map 2
See below for details
RD
15
14
13
12
11
10
9
8
7
6
5
4
3
2
1
0
The value of channel map contains 16 binary numbers. “0” means the corresponding channel is not in use while “1”
means the corresponding channel is in use.
Numbers “0”~“3” correspond to RF channels “1~4” of Master AU(0)
Numbers “4”~“7” correspond to RF channels “1~4” of Slave AU(1)
Numbers “8”~“11” correspond to RF channels “1~4” of Slave AU(2)
Numbers “12”~“15” are not in use and should be all zero.
For example, the value “0000 0100 0010 0001” means that the first channel on the Master AU and the second
channel on the Slave AU1 and the third channel on the Slave AU2 are now in use, while all others are not in use.
Table 49 RU Advanced Commands
Command
Description
RD/RW
Hardware Reset
/
RW
Software Reset
/
RW
Wi-Fi module reset
/
RW
Initialization/Alarm report
Initialization: Clear and disable all alarms；
Report site launch: Report to OMC when new site launches；
RW
Alarm mode selection
Normal mode = 3 minutes / Test mode = 1 minute
RW
5.4.8. RU Command
Table 50 RU Factory Parameters
Factory pattern
To perform Device Initialization functions, factory authorization is required.
RW
Factory pattern password
Reserve
RW