User's Manual

CrossFire HP – All-Digital Transport System

User Guide

6.2.1. Inspecting the Packing Container

Handle the packing container carefully. Inspect the packing container immediately on arrival at the installation site

to verify that no obvious damage occurred during shipment. Ensure that the container is sound and that the waterproof

and vibration warning notices are still obvious.

If any damage is observed, notify

SUNWAVE immediately. Do not open or unpack the container until SUNWAVE

personnel have inspected it.

A SUNWAVE engineering technician will attend the installation site to inspect and unpack the shipment with the

customer. The technician will complete a shipment arrival and inspection report.

6.2.2. Unpacking the Device

If the container appears to be in satisfactory condition, perform the following procedures to unpack the device:

1. Ensure both user and supplier representatives are in attendance during shipment inspection.

2. Confirm where the device is to be stored.

3. Ensure procedures are in place to handle the device and other equipment properly, after it has been unpacked

and inspected.

4. Ensure the following tools are available to unpack the shipment: hammer, paper cutter and crow bar.

5. Open the packing container carefully. The device is contained in a protective package inside the packing

container; however, caution is still necessary so as not to damage the internal package and device.

6. Remove the internal package from the packing container.

7. Unpack the device from the internal package carefully.

6.2.3. Verifying the Contents

To verify the contents of the package:

1. Verify that the contents and quantities agree with the Delivery Packing List.

2. Check the device model against the Delivery Packing List.

3. Notify

SUNWAVE immediately if any discrepancies are discovered, to verify whether the complete and correct

shipment has been received.

6.2.4. Inspecting the Device

After unpacking the device, place the device on solid ground and check the following to ensure the device has not

been damaged:

1. Inspect the device’s appearance, overall dimensions and weight.