User's Manual

CrossFire HP – All-Digital Transport System
User Guide
© SUNWAVE COMMUNICATIONS LIMITED 2015 81 Revision 05
Show/hide parameter ID numbers. Every parameter can be distinguished by its unique ID number in the
WebOMT.
Show/hide configurable parameters.
Note: only some of the read-write parameters are configurable and can be modified.
Save configuration. Note: this button is only enabled after checking the selected parameter. Otherwise, it is
greyed-out and is an invalid choice.
To configure the parameters, use the following procedure and refer to Figure 7-9 and Figure 7-10:
1. In the WebOMT, select the appropriate tab (for example, the User Para tab).
2. Click the
button to show the parameter ID numbers. See 1 in Figure 7-9.
3. Click the
button to show the configurable parameter choice box. See 2 in Figure 7-9.
4. Check the parameter that you want to configure. See the blue check mark in
3 in Figure 7-9.
5. Click the
button to save the configuration. See 4 in Figure 7-9. Note: you can also use the Save
Configuration button on the Configuration page shown in Figure 7-10. (See next step.)
6. Click the Configuration button. (See 5 in Figure 7-9.) This takes you to the Configuration page. In Figure 7-10,
the underlined file contains the configuration parameter data. Use the Download and Load Configuration
buttons to save the file to a local PC and load the file to the WebOMT, respectively. See the red frames in
Figure 7-10.