User's Manual

Mid POWER
Digital Radio
© Sunwave MP_PS_User Manual | 5 of 46
Contact us today:
www.sunwave.com
[e-mail]
Preface
Warnings
All the following “Safety Precautions” must be observed during the entire installation and operation of the CrossFire system.
The CrossFire system components are designed for maximum safety and reliability when they are installed, used, and maintained by
trained and qualified technicians following the procedures and instructions contained in this manual. To assure the safe operation of
your system, always follow the safety and operational recommendations in this manual.
⚫ MP_PS is not a consumer product. Please install and use MP_PS in accordance with the instructions.
⚫ Before installing or modifying any MP_PS equipment, read and fully understand the entire instructions in this guide.
⚫ Only qualified personnel are authorized to install and maintain the MP_PS.
⚫ Changes or modifications to the MP_PS equipment not expressly approved by the manufacturer could void the product
warranty and the user’s authority to operate the equipment.
⚫ Follow Electro Static Discharge precautions to avoid any damage to PCB, PSU, etc.
⚫ Keep equipment powered-off during installing or modifying.
⚫ Low path loss cables connected to antennas are highly recommended.
⚫ This is NOT a CONSUMER device. It is designed for installation by FCC LICENSEES and QUALIFIED INSTALLERS. You MUST have
an FCC LICENSE or express consent of an FCC License to operate this device. Unauthorized use may result in significant
forfeiture penalties, including penalties in excess of $100,000 for each continuing violation.
⚫ This is NOT a CONSUMER device. It is designed for installation by an installer approved by an ISED licensee. You MUST have an
ISED LICENCE or the express consent of an ISED licensee to operate this device.
⚫ Il ne s'agit PAS d'un dispositif CONSOMMATEUR. Il est conçu pour être installé par un installateur agréé par un titulaire de
licence ISED. Vous devez avoir un LICENCE ISED ou le consentement exprès d'un titulaire de licence de l'ISED pour l'utilisation
de cet appareil.
⚫ To comply with FCC RF exposure compliance requirements, each individual antenna used for this transmitter must be installed
to provide a separation distance greater than 160cm or more from all persons during normal operation and must not be co-
located with any other antenna for meeting RF exposure requirements.
⚫ Pour se conformer aux exigences FCC en matière d’exposition RF, chaque antenne utilisée pour cet émetteur doit être installée
pour assurer une distance de séparation supérieure ou supérieure à 160 cm de toutes les personnes pendant le
fonctionnement normal et ne doit pas être co-localisée avec une autre antenne pour satisfaire aux exigences d’exposition RF.
⚫ Antenna gain should not exceed 0 dBi.
⚫ Le gain d’antenne ne doit pas dépasser 0 dBi
Note: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device
may not cause harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.