Installation Manual

NANO POWER
20dBm Octa Band
Digital Radio
© Sunwave IM_CF_N2 v1.0.1 |
5
of
24
Contact us today:
www.sunwaveglobal.com
[e-mail]
General
The CrossFire system components are designed for maximum safety and reliability when they are installed, used, and maintained by
trained and qualified technicians in accordance with the procedures and instructions contained in this manual. To assure the safe
operation of your system, always follow the safety and operational recommendations in this manual.
Warnings
 CrossFire is not a consumer product. Please install and use CrossFire in accordance with the instructions.
 Before installing or modifying any equipment of CrossFire, read and fully understand the entire instructions in this guide.
 Only qualified personnel are authorized to install and maintain the CrossFire system.
 Changes or modifications to the CrossFire equipment not expressly approved by the manufacturer could void the product
warranty and the user’s authority to operate the equipment.
 Follow Electro Static Discharge precautions to avoid any damage of PCB, PSU etc.
 Keep equipment powered-off during installing or modifying.
 Low pathloss cables connected to antennas are highly recommended.
 This is NOT a CONSUMER device. It is designed for installation by FCC LICENSEES and QUALIFIED INSTALLERS. You MUST have an
FCC LICENSE or express consent of an FCC License to operate this device. Unauthorized use may result in significant forfeiture
penalties, including penalties in excess of $100,000 for each continuing violation.
 This is NOT a CONSUMER device. It is designed for installation by an installer approved by an ISED licensee. You MUST have an
ISED LICENCE or the express consent of an ISED licensee to operate this device.
 To comply with FCC RF exposure compliance requirements, each individual antenna used for this transmitter must be installed
to provide a separation distance greater than 20cm or more from all persons during normal operation and must not be co-
located with any other antenna for meeting RF exposure requirements.
 To comply with RSS-102 RF exposure compliance requirements, each individual antenna used for this transmitter must be
installed to provide a separation distance greater than 20cm or more from all persons during normal operation and must not be
co-located with any other antenna for meeting RF exposure requirements.
 Cet équipement est conforme aux limites d'exposition aux radiations IC CNR‐102 établies pour un environnement non contrôlé.
Cet équipement doit être installé et utilisé avec une distance minimale de 20 cm entre le radiateur et votre corps.
 Antenna gain should not exceed 3 dBi.
Note: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation.