Installation Manual

HIGH POWER
43dBm Dual Band
Digital Radio
© Sunwave IM_CF_H2 v1.0.0 | 5 of 45
Contact us today:
www.sunwave.com
[e-mail]
Preface
Safety Instructions
All the following “Safety Precautions” must be observed during the entire installation and operation of the CrossFire system.
The CrossFire system components are designed for maximum safety and reliability when they are installed, used, and maintained by
trained and qualified technicians in accordance with the procedures and instructions contained in this manual. To assure the safe
operation of your system, always follow the safety and operational recommendations in this manual.
1. The shells of the device have protective ground terminals. During installation, connect the ground terminals securely to the
protective building ground with yellow and green conductors or with braided ground wire. The aerial and feeder must be
adequately grounded.
2. The power source must be within the required range of the device. The rated voltage range for the AC power supply system is
100 ~ 240VAC, and the rated frequency range is 50Hz / 60Hz. The rated power of the A2, E2, and H2RU is 80W, 60W, and
250W, respectively. The ground terminal of the three-core power socket used at the device installation site must be securely
connected to the protective building ground.
3. To avoid injuries or damage, use care, and obtain assistance before lifting any heavy system components or equipment.
4. While fiber optic power levels used in this system are very low, it is advisable to avoid exposing the human eye to the laser light
emanating from a fiber port or plug.
5. Signals coupled from the BTS shall be no greater than +15dBm, otherwise, the device will not operate normally, and damage
may occur to the circuit.
6. Reserve at least 40mm of height above the radiation fins during device installation; otherwise, the device temperature may rise
and affect the service life of the device.
7. Please use Shielded Twisted Pair (STP) cables for WLAN application.
8. Low path loss cables connected to antennas are highly recommended.
9. The socket-outlet shall be easily accessible.
FCC Warning:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired operation.
IC Warning:
l'appareil contient des émetteurs/récepteurs exempts de licence qui sont conformes aux CNR exempts de licence d’Innovation,
Sciences et Développement économique Canada. L’exploitation est soumise aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage,
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.