Installation Manual

MID POWER
4 x 37dBm Output
5G NR Compli
© Sunwave IM_CF_M2 v2.0.1 | 15 of 51
Contact us today:
www.sunwave.com
[e-mail]
3. Place the A2 in the rack and secure the A2 using 2 screws M6×16 on both side and the Phillips screwdriver.
4. Install the fan for cooling if multiple A2s are installed in the same rack.
It is necessary to allow at least 3 rack unit (132mm) of free space below each unit for heat dissipation without fan installed or 1
rack unit (44mm) of free space below each unit with fan occupied in the middle.
Otherwise, the device temperature may rise and affect the service life of the device.
5. Connect and lock the power cable at the A2 rear side.