Installation Manual

MID POWER
4 x 37dBm Output
5G NR Compli
© Sunwave IM_CF_M2 v2.0.1 | 23 of 51
Contact us today:
www.sunwave.com
[e-mail]
RF Connection
The RF interface between the Access Unit and the service provider signal source (or CrossFire CPOI) is provided by duplex
connections on the Active Combiner module.
To route and connect the coaxial cables to the Access Unit:
1. Obtain the required lengths of high performance, flexible, low loss 50Ω coaxial cable for all coaxial connections and route the
cables from the signal source or CPOI to the Active Combiner module.
2. Connect the cables from the signal source to the QMA female connectors on the Active Combiner module on the back panel of
Access Unit.
Note: Each Active Combiner module has four connectors to support up to four inputs.
A2 Rear Panel Interfaces
SN Interface Name Description
1
Module 4
Duplexer Interface
QMA Female
2
Module 3
Duplexer Interface
QMA Female
3
Module 2 Duplexer Interface
QMA Female
4
Module 1 Duplexer Interface
QMA Female
5
Electric Power Line Interface
/
6
Grounding
/
Installation of the E2-O
Installing the E2-O is virtually the same as installing the A2. Please refer to the steps described in the A2 installation for the E2-O.