Installation Manual

MID POWER
4 x 37dBm Output
5G NR Compli
© Sunwave IM_CF_M2 v2.0.1 | 5 of 51
Contact us today:
www.sunwave.com
[e-mail]
Preface
Safety Instructions
All the following “Safety Precautions” must be observed during the entire installation and operation of the CrossFire system.
The CrossFire system components are designed for maximum safety and reliability when they are installed, used, and maintained by
trained and qualified technicians in accordance with the procedures and instructions contained in this manual. To assure the safe
operation of your system, always follow the safety and operational recommendations in this manual.
1. M2RU is not a consumer product. Please install and use M2RU in accordance with the instructions.
2. Before installing or modifying any M2RU equipment, read and fully understand the entire instructions in this guide.
3. Only qualified personnel are authorized to install and maintain the M2RU.
4. Changes or modifications to the M2RU equipment not expressly approved by the manufacturer could void the product
warranty and the user’s authority to operate the equipment.
5. The shells of the device have protective ground terminals. During installation, connect the ground terminals securely to the
protective building ground with yellow and green conductors or with braided ground wire. The aerial and feeder must be
adequately grounded.
6. The power source must be within the required range of the device. The rated voltage range for the AC power supply system is
100 ~ 240VAC, and the rated frequency range is 50Hz / 60Hz. The rated power of the A2, E2-O, and M2RU is 80W, 60W, and
150W, respectively. The ground terminal of the three-core power socket used at the device installation site must be securely
connected to the protective building ground.
7. To avoid injuries or damage, use care, and obtain assistance before lifting any heavy system components or equipment.
8. While fiber optic power levels used in this system are very low, it is advisable to avoid exposing the human eye to the laser light
emanating from a fiber port or plug.
9. Signals coupled from the BTS shall be no greater than +15dBm, otherwise, the device will not operate normally, and damage
may occur to the circuit.
10. Reserve at least 40mm of height above the radiation fins during device installation; otherwise, the device temperature may rise
and affect the service life of the device.
11. Follow Electro Static Discharge precautions to avoid any damage to PCB, PSU, etc.
12. Keep equipment powered-off during installing or modifying.
13. Low path loss cables connected to antennas are highly recommended.
14. This is NOT a CONSUMER device. It is designed for installation by FCC LICENSEES and QUALIFIED INSTALLERS. You MUST have
an FCC LICENSE or express consent of an FCC License to operate this device. Unauthorized use may result in significant
forfeiture penalties, including penalties in excess of $100,000 for each continuing violation.
15. This is NOT a CONSUMER device. It is designed for installation by an installer approved by an ISED licensee. You MUST have an
ISED LICENCE or the express consent of an ISED licensee to operate this device.