User manual

As previously stated a length of cord or wire should be taped or tied to the loom, feed through the conduit
supplied (the flanged end is positioned nearest to the fan), keeping the loom taut slide the conduit through the
mounting plate. Locate over the extruded hole at the rear of the gather and measure the distance to be trimmed
i.e. between the mounting plate and the underside of the flanged conduit. Remove the conduit and cut to length
(from the gather end) removing any burrs from the inside, refit and revolve the conduit so that the flange is
located between the plate and the tag. See Fig. 17.
Assemble the fan support plate to the mounting plate by feeding the wiring harness through the extruded hole
in the rear of the support plate. Slide the flue spigot over the flue tube, holding the loom taut and secure to the
mounting plate with the four fixing screws provided. Secure the loom to the base with a cable tie and connect
the six wires to the connector block and the earth lead to the earthing post as shown In Fig. 18. Excess loom
should be laid between the channel (Fig. 10) avoiding any contact with the fan housing, a cable tie is supplied
should it be required. Replace the rear deflector (this directs cool air onto the fan bearings to prevent excessive
temperatures), replace cover in position.
If a terminal guard is to be fitted (available from your supplier) GC 292-029. This should be positioned so
there is a minimum clearance to 50mm from any part of the fan housing and screwed to the wall using suitable
plastic plugs and screws.
Connecting the Gas Supply
A guide to the requirements of supplying gas to the appliance appears on page 6.
With the gas burner assembly removed the knockout blanks are evident and a supply pipe can be routed to the
burner via an isolation cock or restrictor elbow as shown In Fig. 4.
In the right hand rear corner of the fire behind the heat shield a blanking tape is located which is also the
means of retaining the mains supply cable with a strain relief grommet to prevent the cable pulling out from
the terminal block. The blanking plate is directed so as the cable entry is from the side, if the cable entry is
preferred to be from the rear remove the screw and revolve the plate to allow a gas supply to be connected
from the right hand side. IMPORTANT: If the heat shield is removed for access it must be replaced prior to
the fire being commissioned.
Page 16