User manual

13. TO REPLACE THE SOLENOID VALVE OR SOLENOID COIL
• Withdraw the burner assembly as detailed in 21 to 2.7.
• To remove the complete valve unscrew the screw in the centre of the plug sufficient to allow the plug to be
removed from the solenoid coil. Disconnect the two compression nuts holding the valve in position
remove the two fittings from the valve body and clean any old thread sealant from the fittings. Replace the
fittings in the new valve using a suitable thread sealant, tighten the two compression nuts and replace the
plug in position. If the coil only is to be exchanged, remove the plug and unscrew the nylock nut and
washer, remove the coil and replace with the new item. Reconnect the burner assembly and solenoid lead
and check for gas leaks.
14. REPLACEMENT OF FIBRE BACK (CHAIRBRICK)
If the fibre back becomes damaged it is possible to replace this component without removing the appliance
from the surround or location, in the unusual event of this being necessary instructions will be supplied with a
replacement fibre back.
Turbo Toaster Brass Trim Assembly
This trim is suitable for installations where a decorative trim is required around an opening or surround.
The trim kit consists of two side plates that are screwed into pre-drilled holes in the side of the hot box. This
will enable the trim to be locked in position flush with the front vertical face of the hot box or extend forward
of the front face up to 30mm, using the slots provided the side plates.
A top strut is supplied for use where a gap may be found above the opening, if the trim is extended forward of
the front face. In many instances this will not be required and may therefore be discarded. To fit the struts
locate the two ends over the two joggled lugs on the side plates. The rear of the trim has 5 tags formed to
enable the trim to slide over and down the flanges of the side plates.
Page 25