User's Manual

DriveCore Install Network Series Power Amplifiers
page 53
Operation Manual
CONDITION: Bridge LED is lit.
POSSIBLE REASON:
• Amplifier is in Bridge Mono mode.
CONDITION: No input signal.
Signal indicator is not flashing even
though audio is applied, and the channel
is ready..
POSSIBLE REASON:
• Input signal level is very low.
Troubleshooting
“Off/Flashing/On” above means that
the LED can be off, or flashing, or on.
DCi Specications
DCi Network Model Channels 2Ω 4Ω 8Ω 16Ω 70Vrms 100Vrms
2|300N 2 150W 300W 300W 150W 300W 300W
2|600N 2 300W 600W 600W 300W 600W 600W
4|300N 4 150W 300W 300W 150W 300W 300W
4|600N 4 300W 600W 600W 300W 600W 600W
8|300N 8 150W 300W 300W 150W 300W 300W
8|600N 8 300W 600W 600W 300W 600W 600W
2|1250N 2 1250W 1250W 1250W 625W 1250W 1250W
4|1250N 4 1250W 1250W 1250W 625W 1250W 1250W
2|2400N 2 2100W 2400W 1900W 950W 2100W 2300W
4|2400N 4 2100W 2400W 1900W 950W 2100W 2300W
Dual-Mode - All Channels Driven
Minimum Guaranteed Power (20 Hz - 20 kHz)