Owners Manual

Page 34 of 66
Gas Conversion Kits
Gas conversion kits are available from Crown Verity to allow the grill to operate on either
Natural gas or LPG. These kits should be installed by a qualified gas technician.
The kits come with complete installation instructions. These instructions should be read
completely and fully understood before installing the conversion kit.
Please contact the Crown Verity customer service desk at: 1-888-505-7240 or
[e-mail] for conversion kit requirements.
Leak Test Procedure
Although all gas connections on the grill are leak tested at the factory prior to
shipment, a complete test must be performed:
1. After installation due to possible mishandling during shipping or installation.
2. Periodic checks are also required every time the propane cylinder is refilled, any gas
component is changed or at least once a year.
3. Immediately check for leaks if you smell gas.
WARNING: Never use an open flame to look for a leak. Perform the leak test outdoors in a
well-ventilated area. Extinguish all open flames and keep away from any heat or ignition
sources. DO NOT SMOKE! Use only a 50/50 mixture of liquid soap and water for leak testing.
IMPORTANT: Owners should only check for leaks on the gas connections that are external to
the grill. If the valves or other internal connections need to be checked, please call a licensed
technician or Crown Verity Customer Service at 1-888-505-7240.
For LP units using a 20 or 30 pound cylinder, a full cylinder should be used.
To Conduct the Test:
Make a soap solution of one part liquid dish soap and one part water. Make sure the
appliance control valve(s) is in the OFF position. Turn the gas supply ON. Use a spray
bottle, brush or rag to apply the mild soap solution to all connections from the supply
line or LP cylinder to the connection on the rear of the appliance including the
following:
1. Cylinder valve including the threads into the tank.
2. All cylinder welds.