Instruction manual

15
7. If the ignition system uses a distributor with points, check the capacitor on the distributor and
also the capacitor on the coil.
8. Try re-routing the input and output cables.
9. Check for a bad alternator.
10. Make sure all power-cable connections are tight and secure.
11. Re-route the power cables.
Service Policies:
Due to the sophisticated circuitry of the CMA-1, only qualified, fully trained technicians should be
allowed to service it.
Specifications:
Output Power: (20Hz-20kHz):
3 Channel Mode: 3x100W @ 8 ohms .1% THD
4 Channel Mode: 2x50W @ 4 ohms .05% THD
2x100W @ 8 ohms .1% THD
5 Channel Mode: 4x50W @ 4 ohms .05% THD
1x100W @ 8 ohms .1% THD
Rated
Typical
Frequency Response
20Hz-20kHz at 1 watt: +/- 1dB +/- .5dB
THD at 50W .05% .04%
at 100W (Bridged) .1% .08%
S/N Ratio: 90dB 100dB
Damping Factor
50Hz-1kHz: 50 100
Input Sensitivity: .775V
Input Impedance: >10K ohm
Supply Voltage: 12-14 VDC
Power Consumption: 73 amps DC max.
10-40 amps DC nominal
Size: 16”L x 14-1/2”W x 3-5/8”H
Weight: 20 lbs.
# # #