User`s manual

Crown Broadcast FME 350W to 2000W User Manual– 05/2013
Page 22
Crown Broadcast, a division of International Radio & Electronics Corporation 25166 Leer Drive, Elkhart, Indiana, 46514-5425 USA
Ph [phone]
To configure the transmitter using the front panel: See section 4.2.
To configure the transmitter using the PC application: See section 4.3.
To set network parameters (TCP/IO option only): See section 4.4.
To use serial commands: See section 6.
4.2. Using the front panel
Please refer to section 5.2 for front panel working principle.
4.2.1. Setting the transmitter
Set the power (in W), the frequency (in MHz) and enable the RF:
98 . 00MHz 0W
From the main screen, press the "Enter” key to display
menus and then the “+” key until you see the TX
Parameters menu.
98 . 00MHz 0W
->TX PARAMETERS>
1 FREQ PFWD
-> 9 8 . 0 0 0
Once you see this screen, press “Enter”.
You may now set the frequency and the power. The arrow
preceding the frequency indicates that this parameter is
selected. Press “Enter” to switch to edit mode.
1 FREQ PFWD
-> 9 8 . 0 0 0
Using the “+” and “–” keys, adjust the frequency starting
with the last digit. Once you’ve reached the desired value,
press “Enter” to go to the next digit. Follow the same
procedure for all digits and confirm with the “Enter” key.
Use the "+" to go the next parameter.
1 FREQ PFWD
104 . 05 -> 0
The arrow now appears before the power. Set the power
in the same way you set the frequency.
After confirming the power value with the “Enter” key,
enable the RF using the front panel button.
1 GO TO
MA I N ->RF
Press the “+” key until you see this screen. When the RF
menu is selected, press “Enter” to return to the list of
menus.